Back To Project Page:

Trigger Installation:

Locate the center of the stock where the sear is located. Drill a 3/32" hole at this location. To determine it is in the correct location, cock the lock hammer back and they poke a 3/32" rod thru the hole and trigger the lock to release the hammer. If it in correct position, the hammer will fall. 

Next, align the trigger plate with the set screw hole in line with the hole you drilled into the stock. This aligns your triggers with the sear perfectly. 

Now inlet the trigger plate into the stock. After the plate is inlet, Place the triggers back onto the trigger plate and inlet everything into the stock. When the trigger plate is inletted. Drill a hole in the tail for a no. 6 wood screw and secure it to the stock. Now we can install the tang bolt thru the barrel tang down into the trigger plate.